Alpine HCE-C200R Bedienungshandbuch PDF herunterladen (Seite 10)

9-EN

ALPINE HCE-C200R 68-09359Z09-A (EN)

Installing to a Rear Window

Assemble the camera mounting 3.

Use the hexagonal wrench 5 to remove the

camera mounting 3 and angle adjustment

screw. Remove the mounting brackets, invert

them, and then secure by tightening the

angle adjustment screw.

Attach the camera to the camera mounting

Pull the camera cable through to the camera

mounting 3, and secure with the hex screws

Loosen the camera mounting 3 and angle

adjustment screw.

Determine the attachment angle, and

carefully tighten the angle adjustment screw.

Remove any dirt, dust, oil or chemicals from

the rear window using a commercially-

available cleaning cloth.

Remove the adhesive seal from the camera

mounting 3, and attach the camera

mounting.

• Attach the camera in a position where it does not obstruct

rear visibility, or touch wipers.

• Install the camera facing up so that the serial label on the

rear of the camera is visible.

Securing the Camera Cable

Secure the camera cable.

Attach the waterproof pad 7 with the

waterproof pad adhesive sheet 8, and

secure any slack cable around the waterproof

pad 7 using the cord clamp 9.

• Ensure the cable does not get caught in the trunk, rear

door(s) or any hinges.

• The cable should go on the outside of car hinges and

harness covers.

• After completing wiring, open and close the trunk and the

rear doors several times to confirm the cable is not getting

caught or rubbing anywhere.

Reverse In

Camera cable

Angle adjustment screw

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Keine Kommentare

Alpine HCE-C200R Bedienungshandbuch Seite 10