Alpine ICS-X7 Betriebsanleitung PDF herunterladen (Seite 67)

67-EN

01GB07ICS-X7.fm

ALPINE ICS-X7 68-21057Z38-A (EN)

Connection Diagram of SPST Switch (sold separately)

(If the ACC power supply is not available)

• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).

• The diagram and the fuse amperage shown above are in the case when ICS-X7 is used individually.

• If the switched power (ignition) lead of the ICS-X7 is connected directly to the positive (+) post of the vehicle’s battery, the ICS-X7 draws some

current (several hundred milliamperes) even when its switch is placed in the OFF position, and the battery may be discharged.

ICS-X7

(Red)

(Yellow)

SPST SW (Optional)

FUSE (5A)

(Optional)

FUSE (20A)

(Optional)

Battery

ACC

BATTERY

To prevent external noise from entering the audio system.

• Locate the unit and route the leads at least 10 cm away from the car harness.

• Keep the battery power leads as far away from other leads as possible.

• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.

• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various

noise suppressors, contact them for further information.

• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.

01GB00ICS-X7.book Page 67 Friday, October 12, 2012 9:24 PM

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 75 76

Keine Kommentare

Alpine ICS-X7 Betriebsanleitung Seite 67